Keep the fan on your own furnace blower to help improve performance and efficiency by allowing air to flow smoothly. First, turn off the oven. This should be done at the fuse box or circuit breaker. Then turn off the oven and the fan in the unit change. So, place your thermostat from. Second, the furnace blower. To do this you must disconnect fan motor wiring Connector. To remove the assembly, remove the screw, then slide. Make sure you touch the terminals of the capacitor, which is probably connected with the side of the tunnel.
Thirdly, if the capacitor is attached to the trailer box, download it and make it. you can find on the capacitor on the side of the case, the son of a pair of nose clips use. Make sure they are insulated grip to prevent electric shock. Also, do not touch the terminals.
You can use drawing to comply resistor-capacitor type. If you do not know how to use it on wheels, call a professional. When the capacitor is discharged, and proceed to delete it. Fourth, to the motor and blower wheel housing. Mark a center shaft on the trailer as this part must be replaced immediately applied to the same. Use the wheel, releasing the iron. Then the box and remove the bolts from the motor support. Also delete deflector housing by removing the iron.
Finally, clean the blower wheel and fan motor. It is easier to use spray car wash wand clean the wheel, but not direct water at the wheel at full pressure to avoid the moment the fan blades. You can clean the engine with a soft brush (without water). Keeping your furnace blower assembly clean can mean lower energy bills and a more comfortable home.
Comments are closed